← Project Planning & Design

Sheet LS-123
PAPPDPDDCE PjM

Exterior Walls & Fire Separationconcept

Exterior wall ratings, opening limits, and parapets (Tables 705.5 / 705.8)

One-line orientation

Once fire separation distance is known, check:

  1. Table 705.5 — wall rating: required exterior-wall fire resistance.
  2. Table 705.8 — openings: how much of the wall may be openings.
  3. Parapet: commonly required for a rated wall, though exceptions apply.

Key points

  • Closer to the line = higher required wall rating. Table 705.5 ties the fire-resistance rating of the exterior wall to the measured fire separation distance (with construction type and occupancy).
  • Closer to the line = smaller / more protected openings. Table 705.8 governs the maximum area of exterior wall openings based on proximity to lot lines or adjacent structures. Very close walls may allow almost no openings; far-enough walls may allow unlimited openings.
  • Openings are limited two ways: by area (how much of the wall can be open) and by protection (whether the opening must be a fire-rated assembly). Both tighten as FSD shrinks.
  • Parapets: required where the exterior wall must be fire-resistance rated — the parapet carries the rated wall above the roof so fire can’t spread over the top.
  • Parapet exceptions exist: notably when the roof assembly is non-combustible or has a 2-hour fire-resistance rating, the parapet may be omitted (plus other code-listed exceptions). A rated wall does not automatically mean a parapet is mandatory.

Confusions / comparison

ItemGoverned byDriven byDirection as FSD shrinks
Exterior wall fire ratingTable 705.5FSD + construction type/occupancyRequired rating increases
Max area of openingsTable 705.8Proximity to lot line / other buildingsAllowable opening area decreases
Opening protection§705.8 / opening protectivesProximity + occupancyMore openings must be protected
Parapet§705.11Whether wall is ratedMore likely required (unless an exception applies)

→ Fire separation distance: how it’s measured (this module): the FSD input that feeds these tables · Code in the design process (this module): when wall ratings and openings get resolved · Fire department access and fire lanes (this module): the other proximity-driven fire requirement.

Spotted an issue with this card? Tell us →

Related units